Improved methods for evaluating the molar mass distributions of cellulose in kraft pulp

Multi‐angle laser light scattering (MALLS) was used to characterize birch kraft pulps with respect to their absolute molecular mass distributions (MMDs). The pulps were dissolved in lithium chloride/N,N‐dimethylacetamide and separated by size exclusion chromatography (SEC). The weight‐average and number‐average molecular masses of the cellulose fractions of the pulps obtained from the absolute MALLS measurements were compared with the molar masses obtained by direct‐standard‐calibration relative pullulan standards. Discrepancies between the two detection methods were found, and two ways of correlating the relative pullulan molar masses to the absolute molar masses were examined. In the first method, the correlation was made over a large range of molecular masses. The second method correlated the molecular masses of the standards to the molecular masses of samples by the calculation of fictitious, cellulose‐equivalent molar masses of the standards. With the preferred second method, a more correct MMD of kraft pulp samples could, therefore, be obtained from an SEC system calibrated with narrow standards. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 1170–1179, 2003     

亚硝酸盐的光催化氧化

利用半导体光催化剂Bi2O3 对含亚硝酸盐废水的处理进行了研究，并讨论了影响亚硝酸盐氧化率的主要因素，实验结果表明：选择活性较高的Bi2O3作为光催化剂，当其用量为0.050g，试液PH=3.70,NO2^--N起始浓度为400.0mg/L，光照1h时，亚硝酸盐的氧化率达到97.0%。     

Dynamic light scattering studies on random cross-linking of polystyrene in semi-dilute solution

The random cross-linking of appropriately functionalized polystyrene in semi-dilute toluene solution (c = 0.01–0.05 g/mL) was studied by time-dependent measurements of dynamic light scattering. Macroscopic gelation occurred from concentrations as low as 0.02 g/mL. The gelation time, determined from the first appearance of fluctuations of the scattering intensity and the initial amplitude of the intensity correlation function (ICF), decreases markedly from about 100 min to 10 min with an increase of polymer concentration or cross-linker content. After the gel point, the ICFs display a characteristic power-law decay. The power-law exponent, n = 0.75 ± 0.06, does not change with (i) extent of reaction, (ii) polymer concentration, and (iii) cross-linker concentration, within the inspected ranges. This universal behavior is traced back to the fact that gelation took place as a result of random cross-linking of existent macromolecules, whose state of solution does not change markedly during conversion.     

新型铝酸酯光稳定剂的研究

合成了五种新型铝酸酯光稳定剂并对其紫外吸收性能、荧光性能和热稳定性能进行了表征，探讨了光稳定剂结构、相对分子质量与其性能的关系，并验证它们的光稳定性及其在PE—LD中的光氧化稳定作用。还与紫外线吸收剂BAD和Tinuvin327进行了应用比较。     

坡缕石/Al掺杂CdS复合材料光催化降解罗丹明B

采用溶剂热法制备了坡缕石/Al掺杂CdS复合材料(PGS/CdS-Al),运用XRD、XPS、SEM、UV-Vis DRS及PL对材料的结构、形貌以及光学性能进行了表征.结果表明,Al元素成功掺杂到CdS中,CdS的晶体结构没有改变,但其禁带宽带变宽.可见光照射下,该复合材料对孔雀石绿、亚甲基蓝、甲基橙、结晶紫、罗丹明B有机染料均有光催化降解活性,且对罗丹明B的光催化降解效果最好.光照40 min,质量浓度为0.67 g/L 15％PGS/CdS-Al(15％为PGS的负载量,以生成的CdS质量计)对30 mL质量浓度为20 mg/L罗丹明B的降解率为98.7％,反应主要活性基团是h+.该降解反应符合一级动力学,反应速率常数为0.067 min–1.     

提高镁回收率的途径及效益分析：白云石碳酸化法生产轻质碳酸镁新工艺研究

本文提出了白云石碳酸化法生产轻质碳酸镁，二次碳酸化法新工艺的理论依据、实验结果及技术经济分析。     

ZigBee和3G的远程无线测光系统设计

设计了基于ZigBee短距离无线通信技术与3G远距离无线通信技术相结合的远程无线测光系统;该系统处理器选用的是三星S5PV210处理器,短距离无线通信模块采用TI公司的CC2530芯片,3G上网卡设备用的是中兴MF190无线上网模块。文中给出了系统具体的软硬件设计方案。结果表明,该系统可以达到稳定高效的监测效果,具有良好的实用性和应用价值。     

Synthesis and light‐emitting properties of new poly(p‐phenylenevinylene) derivatives containing oxadiazole moiety

Two new poly(p‐phenylenevinylene) (PPV) derivatives containing oxadiazole moiety (OXA‐PPV1 and OXA‐PPV2) were synthesized by the Wittig condensation polymerization reaction. Their thermal and light‐emitting properties were investigated. The single‐ and triple‐layer electroluminescent (EL) devices with configurations of ITO/polymer/Al and ITO/polymer/OXD‐7/Alq₃/Al were fabricated. They exhibited blue emission at 470 nm for OXA‐PPV1 and green emission at 560 nm for OXA‐PPV2. The turn‐on voltages of triple‐layer device were 11 V for OXA‐PPV1 and 8 V for OXA‐PPV2. The triple‐layer EL devices showed much better performance than did the single‐layer devices. The spectra indicated energy transfer occurred from segments of side chain to polymer backbone. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 422–428, 2002     

削弱或抑制抗氧剂、光稳定剂作用的有关因素

介绍了削弱或抑制抗氧剂、光稳定剂作用的常见因素及实例，分析了防老化塑料制品发生提前老化现象的可能性和原因。     

Al_2O_3负载TiO_2光催化氧化剂的制备与性能试验

以钛酸四丁酯为钛源、Al2O3为载体,采用浸渍法制备了一系列TiO2/Al2O3复合氧化物光催化剂。以光催化降解甲醛为探针反应,考察了催化剂的光催化活性。并采用XRD、SEM技术对催化剂进行了表征。考察了催化剂的焙烧温度、钛含量、反应温度等因素对甲醛光催化降解率的影响。结果表明:400℃是制备TiO2/Al2O3光催化剂的最佳焙烧温度;在TiO2负载质量为5.0%的复合氧化物光催化剂催化效果最好,甲醛的降解率达到58.4%。随着反应温度的升高,复合氧化物光催化剂的催化性能下降,由25℃时的58.4%的甲醛降解率下降到50℃时的4.8%。